Hole punching just doesn t seem to work for the clients at t

Question

Hole punching just doesn t seem to work for the clients at the office network so I thought about using the local DMZ server as a relay because that one actually can be connected to Unfortunately once I turn this node into a relay all the nodes I want it to relay attempt to connect to it by using the public ip address of the server instead of the local ip address This normally wouldn t cause issues but in this network it fails because trying to connect to the public IP address from within the network always fails So is there something I can do about that

jolly-london-20127 · Answer

have you played around with endpoint and local address here

enough-fireman-67878 · Answer

No I let it remain as its local ip address which is 192 168 50 187 in this case

jolly-london-20127 · Answer

a node will only connect over the local address if the other node has the same public endpoint

jolly-london-20127 · Answer

though maybe we skip that check if it s a relay

jolly-london-20127 · Answer

you could try turning off dynamic endpoint and setting endpoint to the local ip

jolly-london-20127 · Answer

but then the relay will be unaccessible outside of this network except from the netmaker server