I will look into that and report back, thanks!

Well I found 1 issue, the MQ-container didn't have this in the config:

listener 8883

So it did not listen on that port🤦‍♂️. I now can actually connect to it with telnet and nmap shows the port is now open. Now i can see the following error in my MQ logs:

1651665669: New connection from 87.253.149.198:55066 on port 8883.
 1651665669: Client <unknown> disconnected due to malformed packet.
 1651665669: New connection from 87.253.149.213:50366 on port 8883.
 1651665669: Client <unknown> disconnected due to malformed packet.
 1651665670: New connection from 87.253.149.198:55068 on port 8883.
 1651665670: Client <unknown> disconnected due to malformed packet.
 1651665672: New connection from 87.253.149.213:50368 on port 8883.
 1651665672: Client <unknown> disconnected due to malformed packet.
 1651665672: New connection from 172.20.0.2:57990 on port 1883.
 1651665672: Client ydRrLDYofXi6kVhDb4XkbGi disconnected, not authorised.
 1651665672: New connection from 172.20.0.2:57992 on port 1883.
 1651665672: Client ydRrLDYofXi6kVhDb4XkbGi disconnected, not authorised.
 1651665673: New connection from 87.253.149.198:55070 on port 8883.
 1651665673: Client <unknown> disconnected due to malformed packet.
 1651665673: New connection from 87.253.149.213:50370 on port 8883.
 1651665673: Client <unknown> disconnected due to malformed packet.

well i fixed it

are you using the new v0.13.X mosquitto conf file?

This was exactly the issue😅

after using this and restarting it it was now fixed i guess

i am seeing subscribed messages in the logs

and my nodes are now healthy again

Thanks for the help!

Maybe this could also be added to the troubleshooting doc? This step does not seem to be included

Hey everyone, I installed netmaker via the script on Github - everything installed fine no errors. However, I can't access the web GUI via domain, public IP, or even the LAN IP of the VM. What should I check?

Ahh, I can visit on the LAN ip with the port manually specified. Must be an issue with Caddy

Im still using 0.9.4 - but I'd like to use the VPN option - I followed the docs on egress gateway but it doesnt seem to work - do I need to upgrade to 0.12 ?

I used the not 0.0.0.0 as per the docs suggestion for egress gateways for this purpose. My clients can't route traffic when connected though

this should work even in 0.9.4, have you tried it with that release?

yes I tried with 0.9.4 on a few clients but they get no internet access - but can ping other nodes on that network

I also just fired up 0.13 on a new VPS to test and same result weirdly

This was a vultr clean vps

how have you configured the gateway?

my first guess is it's the wrong inteface

I used the interface enp1s0 which shows the public ip

should I be using 0.0.0.0/0 or the large list of public ips 10.201.0.0/16,0.0.0.0/5,.......

I would stick with the large list

but maybe try a different interface

also, make sure the list of IP's shows up in AllowedIPs on the clients

yeh shows on allowed list on clients

VPS only has that 1 interface, other than docker interfaces

hmmm

weird - cant ping the netmaker server either